Copier Trouble; Misfeed Removal - Sharp AR-151 Operation Manual

Digital laser copier

Hide thumbs Also See for AR-151:

Table of Contents

This chapter describes misfeed removal and troubleshooting.

When the misfeed (

of a misfeed.

If a misfeed occurs when using the SPF, a number may appear in the display after a minus

sign. This indicates the number of the originals that must be returned to the document feeder

tray after a misfeed. Return the required number of originals. Then this number will disappear

when copying is resumed or the clear (

When the SPF misfeeds an original sheet, the copier will stop and the SPF misfeed ( ) indicator

will blink, while the misfeed (

see page 38.

If the misfed paper is seen from

this side, proceed to "C Misfeed in

the transport area". (p. 28)

01C-5.p65

Downloaded from:

http://www.usersmanualguide.com/

COPIER TROUBLE?

) indicator blinks or

) indicator will remain off. For a misfeed of originals in the SPF,

Ensure that the bypass tray is open and then open the side cover while pressing the

side cover open button.

Check the misfeed location. Remove the misfed paper following the instructions for

each location in the illustration below.

blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 27)

blinks in the display, the copier will stop because

) key is pressed.

If paper is misfed here, proceed to "B

Misfeed in the fusing area". (p. 27)

If paper is misfed here, proceed to "A

Misfeed in the paper feed area". (p. 27)

2/11/00, 15:57

Table of Contents