Juniper SRX4600 Quick Start Manual page 3

7. Continue to support the device and slide the rear mounting blades into the channel of the side mounting rails and
securing the blades to the rack. Use the four mounting screws (cage nuts and washers if the rack requires) to attach
each blade to the rack.
8. Attach a grounding cable to earth ground and then attach it to the chassis grounding points.
Connect the SRX4600 to Ground
To connect the Firefall to the ground:
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
2. Connect one end of the grounding cable to a proper earth ground, such as the rack in which the services gateway is
mounted.
3. Place the grounding lug attached to the grounding cable over the protective earthing terminal on the protective
earthing terminal bracket.
4. Secure the grounding lug to the protective earthing terminal with the washers and screws.
5. Dress the grounding cable and ensure that it does not touch or block access to other device components and that it
does not drape where people could trip over it.
Connect Power to the SRX4600
IN THIS SECTION
Connect Power to an AC-powered SRX4600 | 4
Connect Power to a DC-powered SRX4600 | 4
3