Juniper SRX4600 Quick Start Manual page 2

• Two AC power cords with plugs appropriate for your geographical location (provided)
• Management host, such as a PC or laptop, with a serial port (not provided)
• A grounding cable (minimum 14 AWG (2 mm²), minimum 90°C wire), a grounding lug (Panduit LCD10-10A-L or
equivalent) (not provided).
• RJ-45 cable and RJ-45 to DB-9 serial port adapter (not provided)
NOTE: We no longer include a DB-9 to RJ-45 cable or a DB-9 to RJ-45 adapter with a CAT5E copper cable
as part of the device package. If you require a console cable, you can order it separately with the part number
JNP-CBL-RJ45-DB9 (DB-9 to RJ-45 adapter with a CAT5E copper cable).
Mount the SRX4600
You can mount an SRX4600 Firewall in a 19-inch four-post rack configuration. An AC device weighs approximately 38
lb (17.23 kg) and a DC device weighs approximately 40 lb (18.14 kg). Two persons are required for mounting the device.
To mount the firewall:
1. Attach the ESD grounding strap to your bare wrist and to a site ESD point.
NOTE: If you are mounting multiple units in the rack, mount the heaviest unit at the bottom and mount the
others from bottom to top in order of decreasing weight.
2. Place the rack in its permanent location, allowing adequate clearance for airflow and maintenance, and secure it to
the building structure.
3. Attach the front-mounting brackets to the side mounting rails by using the Phillips 4-40 flat-head mounting screws.
4. Align the holes in the side mounting rails with the holes on the side of the chassis and attach the side mounting rails
to the chassis by using the mounting screws.
5. Have one person grasp both sides of the device, lift it, and position it in the rack so that the front bracket is aligned
with the rack holes and the second person secure the front of the device to the rack by using four mounting screws.
6. Have the second person use the mounting screws (and cage nuts and washers if your rack requires them) to screw
the mounting bracket to the rack.
2