Yamaha 5KM2-AE1 Service Manual page 241

MIDDLE GEAR
2.Install:
Bearing retainer 1
G
*****************************************************
Installation steps:
Attach the folded rag 2.
G
G
Secure the bearing housing edge in the vise.
Attach the bearing retainer wrench 3.
G
Bearing retainer wrench:
P/N. YM-04128, 90890-04128
G
Tighten the bearing retainer.
CAUTION:
The middle driven shaft bearing retainer
has left-handed threads. To tighten the
retainer turn it counterclockwise.
Bearing retainer:
110 Nm (11.0 m • kg, 80 ft • lb)
*****************************************************
3.Install:
Shims 1
G
Bearing housing
G
NOTE:
Install the shims so that the tabs are positioned
as shown in the illustration.
4.Install:
Universal joint yoke (rear side)
G
Washer
G
Nut 1
G
LT
NOTE:
Use the universal joint holder 2 to hold the
yoke.
Universal joint holder:
P/N. YM-04062, 90890-04062
4 - 95
ENG
LT
97 Nm (9.7 m • kg, 70 ft • lb)