Table of Contents
Advertisement
4
Technical description of the burner
4.1
Technical data
Type
Output - Thermal power
(with air at 20 °C)
Fuel
Electrical supply
Motor
Capacitor
Ignition transformer
Pump
Absorbed electrical power
4.2
Burner description
3
8
1
Kerosene pump
2
Control box
3
Reset button with lock-out lamp
4
Flange with insulating gasket
5
Air damper adjustment screw
4.3
Burner equipment
Flange with insulating gasket .............................................. No. 1
Screw of by-pass pump....................................................... No. 1
2903310
Technical description of the burner
484 LD2X
1.0 - 1.5 kg/h
12 - 18 kW
Kerosene, viscosity 1.6 – 6 mm
Run current 0.85 A – 2700 rpm – 283 rad/s
Kerosene, maximum pressure 10 bar (145 psi)
0.115 kW
10
9
5
4
8
744 T2SX
1.5 - 2.1 kg/h
18 - 25 kW
2
/s at 20 °C (Hi = 11.97 kWh/kg)
Single phase, ~ 50Hz 230 V ± 30%
4.5 F
Secondary 8 kV – 25 A
1
6
Pump pressure adjustment screw
7
Pressure gauge port
8
Flame sensor
9
Blast tube
10
Snorkel
The hoses supplied with this burner set for
Kerosene use are not suitable for use with Gas oil
containing a Bio blend.
WARNING
Please refer to the spare part list for the specific
hoses suitable for bio fuel use.
In case of use with gas oil containing up to 10%
Bio blend, it will be essential to use flexible oil
lines suitable for bio fuel use.
Please contact Riello for further information.
GB
744 T2K
2.1 - 2.7 kg/h
25 - 32 kW
0.16 kW
2
Tab. A
6
7
D7531
Fig. 1
Advertisement
Table of Contents
