To Remove And Replace The Fan; To Remove And Replace The Line Filter - HP 1660C Series Service Manual

Replacing Assemblies

To remove and replace the fan

To remove and replace the fan
Using previous procedures, remove the following assemblies:
1
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive Assembly
•
Power Supply
•
Rear Panel
Remove the four fan screws.
2
Lift the fan away from the rear panel.
3
Lift the fan guard away from the rear panel.
4
Reverse this procedure to install the fan.
5
When installing the fan, verify the correct orientation of the fan. If you mount the fan
backwards, the instrument will overheat. Also, check the correct polarity of the fan cable.

To remove and replace the line filter

Using previous procedures, remove the following assemblies:
1
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive Assembly
•
Power Supply
•
Rear Panel
Unsolder the ground wire from the lug on the rear panel.
2
Disconnect the line filter cable from the power supply.
3
Remove the two screws attaching the line filter to the rear panel.
4
Slide the line filter assembly out toward the rear.
5
Reverse this procedure to install the line filter.
6
6–16