HP 1660C Series Service Manual page 6

Contents
To test the single-clock, single-edge, state acquisition (logic analyzer) 3-24
Set up the equipment 3-24
Set up the logic analyzer 3-25
Connect the logic analyzer 3-27
Verify the test signal 3-29
Check the setup/hold combination 3-31
Test the next channels 3-36
To test the multiple-clock, multiple-edge, state acquisition (logic analyzer) 3-37
Set up the equipment 3-37
Set up the logic analyzer 3-38
Connect the logic analyzer 3-40
Verify the test signal 3-42
Check the setup/hold with single clock edges, multiple clocks 3-44
Test the next channels 3-48
To test the single-clock, multiple-edge, state acquisition (logic analyzer) 3-49
Set up the equipment 3-49
Set up the logic analyzer 3-50
Connect the logic analyzer 3-52
Verify the test signal 3-54
Check the setup/hold with single clock, multiple clock edges 3-56
Test the next channels 3-59
To test the time interval accuracy (logic analyzer) 3-60
Set up the equipment 3-60
Set up the logic analyzer 3-61
Connect the logic analyzer 3-64
Acquire the data 3-64
To test the CAL OUTPUT ports (oscilloscope) 3-65
Set up the equipment 3-65
Set up the logic analyzer 3-66
Verify the DC CAL OUTPUT port 3-67
Set up the logic analyzer 3-68
Verify the AC CAL OUTPUT port 3-68
To test the input resistance (oscilloscope) 3-69
Set up the equipment 3-69
Set up the logic analyzer 3-70
Connect the logic analyzer 3-71
Acquire the data 3-72
Perform an operational accuracy calibration 3-72
vi