Biostar NF500-A2G Setup Manual page 79

NF500-A2G / NF500 AM2
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O Address.
The Choices: 378/IRQ 7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
This item allows you to determine how the parallel port should function. The
default value is SPP .
The Choices:
SPP (de fault)
EPP
ECP
ECP +EPP
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices: 3 (default), 1.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple
sectors read / write. If your IDE hard drive supports block mode (most new
drives do), select Enabled fo r automatic detection of the optimal number of
block mode (most new drives do), select Enabled for automatic detection of the
optimal number of block read / write per sector where the drive can support.
The Choices: Enabled (default), Disabled.
Using P arallel port as Standard P rinter Port.
Using P arallel P ort as Enhanced P arallel Port.
Using P arallel port as Extended Capabilities P ort.
Using P arallel port as ECP & EPP mode.
25