Table of Contents
Advertisement
Configure IEEE 802.1x Authentication for a Wired or a Wireless Network
Using Web Based Management (Web Browser)
•
If you configure your machine using EAP-TLS authentication, you must install the client certificate issued by
a CA before you start configuration. Contact your network administrator about the client certificate. If you
have installed more than one certificate, we recommend writing down the certificate name you want to use.
•
Before you verify the server certificate, you must import the CA certificate issued by the CA that signed the
server certificate. Contact your network administrator or your Internet Service Provider (ISP) to confirm
whether a CA certificate import is necessary.
You can also configure IEEE 802.1x authentication using Wireless setup wizard from the control panel
(Wireless network).
1. Start your web browser.
2. Type "https://machine's IP address" in your browser's address bar (where "machine's IP address" is the
machine's IP address).
For example:
https://192.168.1.2
If you are using a Domain Name System or enable a NetBIOS name, you can type another name, such as
"SharedPrinter" instead of the IP address.
For example:
https://SharedPrinter
If you enable a NetBIOS name, you can also use the node name.
For example:
https://brn123456abcdef
The NetBIOS name can be found in the Network Configuration Report.
3. If required, type the password in the Login field, and then click Login.
The default password to manage this machine's settings is located on the back of the machine and marked
"Pwd".
4. Go to the navigation menu, and then click Network.
Start from
, if the navigation menu is not shown on the left side of the screen.
5. Do one of the following:
•
For the wired network
Click Wired > Wired 802.1x Authentication.
•
For the wireless network
Click Wireless > Wireless (Enterprise).
6. Configure the IEEE 802.1x authentication settings.
•
To enable IEEE 802.1x authentication for wired networks, select Enabled for Wired 802.1x status on the
Wired 802.1x Authentication page.
•
If you are using EAP-TLS authentication, you must select the client certificate installed (shown with
certificate name) for verification from the Client Certificate drop-down list.
•
If you select EAP-FAST, PEAP, EAP-TTLS, or EAP-TLS authentication, select the verification method
from the Server Certificate Verification drop-down list. Verify the server certificate using the CA
certificate, imported to the machine in advance, issued by the CA that signed the server certificate.
129
Hide quick links:
Advertisement
Table of Contents
