Connections; Connecting The Fm And Am (Mw) Antennas - JVC TH-P7 Instructions Manual

Connections

Connecting the FM and AM
(MW) antennas
7 AM (MW) loop antenna
Setting up supplied AM (MW) loop antenna
If the antenna cord is covered with the
insulation coat, twist and pull the
insulation coat off and remove.
Connecting AM (MW) loop antenna
White
• Turn the loop antenna until you have the best reception
during AM (MW) broadcast program reception.
NOTE
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or power cords. This could cause
poor reception.
7
Do not connect the power cord until all other connections have been made.
Black
If reception is poor
AM (MW) loop
antenna (white)
Outdoor single vinyl-covered wire
antenna (not supplied)
7 FM antenna
Center unit
If reception is poor
Center unit
Outdoor FM antenna (not
Standard type (75 Ω
coaxial) connector
NOTE
• We recommend that you use coaxial cable for the FM
antenna as it is well-shielded against interference.
Center unit
FM antenna (supplied)
Extend the supplied FM antenna
horizontally.
supplied)
Outdoor FM antenna cord
(not supplied)