Installing The Display Assembly - Dell P92F Service Manual

Steps
1. Remove the two screws (M2x4) that secure the display-cable bracket to the system board.
2. Lift the display-cable bracket off the system board.
3. Push the camera cable and the display cable away from the system board to disconnect the cables from the system board.
4. Disconnect the camera cable and the display cable away from the system board.
5. Remove the three screws (M2.5x6) that secure the left display hinge to the palm-rest and keyboard assembly.
6. Remove the three screws (M2.5x6) that secure the right display hinge to the palm-rest and keyboard assembly.
7. Lift the left and right display hinges from the palm-rest and keyboard assembly.
8. Slide the palm-rest and keyboard assembly from the display assembly.
9. After performing all the above steps, you are left with the display assembly.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display cable and the display hinges and provide a visual representation of the
installation procedure.
40 Removing and installing components