Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (1 > 2 > 3 > 4 > 5 > 6), as indicated by the numbers on the heat sink, tighten the six screws (M2x6.5)
that secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
36
Removing and installing components
After working inside your
Before working inside your
computer.
computer.