Antenna; Removing The Antenna - Dell P92F Service Manual
Hide thumbs
Also See for P92F:
- Service manual (77 pages) ,
- Technical manualbook (38 pages) ,
- Setup and specifications (25 pages)
Table of Contents
Advertisement
NOTE:
Apply sufficient torque when tightening the two screws (M2x4) to avoid damaging the screw threads.
Next steps
1. Install the
I/O
board.
2. Install the
right
fan.
3. Install the
left
fan.
4. Install the
heat sink (for systems shipped with an integrated graphics card)
discrete graphics
card).
NOTE:
The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
5. Install the
M.2 2230 solid-state drive
6. Install the
M.2 2230 solid-state drive
7. Install the
memory
modules.
8. Install the battery.
9. Install the
base
cover.
10. Follow the procedure in
Antenna
Removing the antenna
Prerequisites
1. Follow the procedure in
NOTE:
The Service Tag of your computer is stored in the system board. Enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE:
Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. Make the appropriate changes again after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
memory
modules.
5. Remove the
M.2 2230 solid-state drive
6. Remove the
M.2 2230 solid-state drive
7. Remove the
heat
sink.
NOTE:
The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
8. Remove the
right
fan.
9. Remove the
left
fan.
10. Remove the
I/O
board.
11. Remove the
display
assembly.
12. Remove the
system
board.
About this task
The following image indicates the location of the antennas and provides a visual representation of the removal procedure.
or the
M.2 2280 solid-state drive
or the
M.2 2280 solid-state drive
After working inside your
Before working inside your
or the
M.2 2280 solid-state drive
or the
M.2 2280 solid-state drive
in the SSD2 slot.
in the SSD1 slot.
computer.
computer.
from the SSD1 slot.
from the SSD2 slot.
or the
heat sink (for systems shipped with a
Removing and installing components
49
Advertisement
Table of Contents
