Dell P92F Service Manual page 51

Steps
1. Place the antennas into the slots on the palm-rest and keyboard assembly.
2. Route the antenna cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the antenna cable to the palm-rest and keyboard assembly.
4. Align the screw holes on the right antenna with the screw holes on the palm-rest and keyboard assembly.
5. Replace the four screws (M2x2) that secure the right antenna to the palm-rest and keyboard assembly.
6. Align the screw holes on the left antenna with the screw holes on the palm-rest and keyboard assembly.
7. Replace the four screws (M2x2) that secure the left antenna to the palm-rest and keyboard assembly.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the I/O board.
4. Install the right fan.
5. Install the left fan.
6. Install the heat sink (for systems shipped with an integrated graphics card)
discrete graphics card).
NOTE: The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
or the heat sink (for systems shipped with a
Removing and installing components 51