Table of Contents
Advertisement
RUGGEDCOM WIN5137
Installation Guide
Figure 8: Connecting DC Power
1. Subscriber Station 2. DC Power Supply 3. Switch or Router
3.
Connect a CAT-5e cable between the ETH/PWR port on the subscriber station and a switch or router.
Section 2.9.2
Connecting the RUGGEDCOM WIN1010 (AC Only)
The RUGGEDCOM WIN1010 is a Power-over-Ethernet injector used to power the subscriber station and distribute
data. The injector provides RJ45 input connectors that include 10/100Base-T transceivers for connection to an IEEE
802.3 (10/100Base-T) compatible device. It receives power from a 100 to 240 VAC power source using an IEC-320-
C14 industry standard connector.
CAUTION!
Electrical hazard – risk of damage to equipment. The power cord provided with the data adapter is
safety certified according to national rules. Do not use a power cord that has not been approved by
Siemens for use with the data adapter.
To connect power and data to the subscriber station, do the following:
CAUTION!
Crushing hazard – risk of damage to equipment. Route all power supply cables so that people cannot
walk on them or place objects on or against them. This can pinch or damage the cords.
1.
Connect an indoor-to-outdoor CAT-5e cable to the Ethernet port on the injector. For information on cable
requirements, refer to
2.
Apply the PoE connector kit to the other end of the CAT-5e cable. For more information, refer to
Section 2.9.4, "Assembling the PoE
3.
Connect the modified end of the cable to the DC/ETH port on the subscriber station.
Connecting the RUGGEDCOM WIN1010 (AC Only)
1
Section 3.6, "IDU to ODU Cable
Connector".
2
3
Specifications".
Chapter 2
Installing the Subscriber Station
17
Advertisement
Table of Contents
