Table of Contents
Advertisement
AXIS Q1615 Mk III Network Camera
Specifications
Status LED behavior and buzzer signal for leveling assistant
For information on the function button used for leveling the camera, see page 48.
Press and hold the function button (2) for more than two seconds to level the camera.
•
When the camera is level, both LEDs are steady green, and the beep is continuous.
•
When the camera is not level, the LEDs flash a combination of red, green and orange, and the beep occurs at slow intervals.
Both LEDs briefly flash green to indicate that the leveling is getting better.
SD card slot
NOTICE
TICE
NO
NO
TICE
• Risk of damage to SD card. Don't use sharp tools, metal objects, or excessive force when inserting or removing the SD card.
Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Unmount the SD card from the device's web interface before removing it.
Don't remove the SD card while the product is running.
This device supports microSD/microSDHC/microSDXC cards.
For SD card recommendations, see axis.com.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.
Buttons
Control button
The control button is used for:
•
Resetting the product to factory default settings. See Reset to factory default settings on page 52.
Function button
Note
Focus assistant is only valid for optional P-iris, DC-iris or manual iris lenses.
Use the function button to activate the following functions:
Leveling assistant - This function helps to make sure the camera is level. To start the leveling assistant, press the button for about
3 seconds. Press again to stop the leveling assistant. The status LED and buzzer signal assist leveling of the camera, see Status LED
behavior and buzzer signal for leveling assistant on page 48. The camera is level when the buzzer beeps continuously.
Focus assistant - This function is used for enabling the focus assistant. To enable the focus assistant, press and very quickly release
the button. Press again to stop the focus assistant. To find out more, see the Installation Guide.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
48
Advertisement
Table of Contents
