Set Up Rules For Events - Axis Q1615 Mk III User Manual

AXIS Q1615 Mk III Network Camera
Configure your device
4. Go to Video > Stream > General and increase Compression.
5. Go to Video > Stream > Zipstream and do one or more of the following:
- Select the Zipstream Strength that you want to use.
- Turn on Optimize for storage. This can only be used if the VMS supports B-frames.
- Turn on Dynamic FPS.
- Turn on Dynamic GOP and set a high Upper limit GOP length value.
Set up network storage
To store recordings on the network, you need to set up your network storage.
1. Go to System > Storage.
2. Click
3. Type the IP address of the host server.
4. Type the name of the shared location on the host server under Network share.
5. Type the username and password.
6. Select the SMB version or leave it on Auto.
7. Select Add share even if connection fails if you experience temporary connection issues, or if the share is not yet
configured.
8. Click Add.
Record and watch video
Record video directly from the camera
1. Go to Video > Image.
2. To start a recording, click
If you haven't set up any storage, click
network storage on page 12
3. To stop recording, click
Watch video
1. Go to Recordings.
2. Click

Set up rules for events

You can create rules to make your device perform an action when certain events occur. A rule consists of conditions and actions.
The conditions can be used to trigger the actions. For example, the device can start a recording or send an email when it detects
motion, or show an overlay text while the device is recording.
Add network storage under Network storage.
.
again.
for your recording in the list.
and . For instructions on how to set up network storage, see Set up
12