Changing The Hydraulic Clutch Fluid - KTM 250 SX-F PRADO 2020 Owner's Manual

Table of Contents

Advertisement

11.46

Changing the hydraulic clutch fluid

Warning
Skin irritation Brake fluid causes skin irritation.
Keep brake fluid out of the reach of children.
Wear suitable protective clothing and safety glasses.
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
Consult a doctor immediately if brake fluid has been swallowed.
Rinse the affected area with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
If brake fluid spills on to your clothing, change the clothing.
Note
Environmental hazard Hazardous substances cause environmental damage.
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
The fluid level rises with increasing wear of the clutch facing discs.
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and clutch lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
Remove screws
Take off cover
F00158-10
(all SX‑F models)
Fill bleeding syringe
fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
On the clutch slave cylinder, remove the protection cap
and mount bleeding syringe
piece on bleeder screw
F01597-10
Only loosen bleeder screw
to the point where filling is possible.
SERVICE WORK ON THE CHASSIS 11
1
.
2
3
with membrane
.
4
with the appropriate hydraulic
p. 143)
4
with an appropriate hose
5
.
5
on the clutch slave cylinder
83

Advertisement

Table of Contents
loading

This manual is also suitable for:

250 xc-f 2020250 sx-f 2020

Table of Contents