KTM 250 SX-F PRADO 2020 Owner's Manual page 86

11 SERVICE WORK ON THE CHASSIS
84
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
Avoid contact between brake fluid and painted
parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
(XC‑F US)
–
Fill bleeding syringe
fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap
and mount bleeding syringe
piece on bleeder screw
F01598-10
–
Only loosen bleeder screw
to the point where filling is possible.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
Avoid contact between brake fluid and painted
parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
–
Now inject the liquid into the system until it emerges from drill
6
hole of the master cylinder without bubbles.
–
Now and then, extract the fluid from the master cylinder reser-
voir to prevent overflow.
–
Tighten the bleeder screw and remove the bleeding syringe
with the hose. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
F00166-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
4
with the appropriate hydraulic
p. 143)
4
with an appropriate hose
5
.
5
on the clutch slave cylinder
4 mm (0.16 in)