KTM 250 SX-F PRADO 2020 Owner's Manual page 76

11 SERVICE WORK ON THE CHASSIS
74
Main work
–
Check throttle cable routing. (
–
Position the fuel tank and fit the two spoilers laterally to the
radiator.
–
Make sure that no cables or throttle cables are trapped or dam-
aged.
–
Attach the fuel tank breather hose to the fuel tank lid.
–
Mount and tighten screws
Guideline
Remaining screws,
F01541-11 chassis
(all SX‑F models)
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
K01034-11
–
Plug in connector
–
Remove the wash cap set. Clean the quick release coupling
thoroughly with compressed air.
Info
Under no circumstances should dirt enter into the
fuel line. Dirt in the fuel line clogs the injection
valve!
–
F01591-11
Lubricate the O-ring and join quick release coupling
Info
Route the cable and fuel line at a safe distance
from the exhaust system.
(XC‑F US)
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
F01565-11
p. 80)
1
with the collar bushings.
M6 10 Nm (7.4 lbf ft)
2
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
3
for the fuel pump.
2
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
4
.