Table of Contents
Advertisement
7381
User's Guide
Unpack the Product
Unpack the Bath carefully and inspect it for damage that may have occurred during shipment. If
there is shipment damage, notify the carrier immediately. Make sure that all components are
present:
•
The Bath
•
Access Hole Cover
•
Fluid Expansion Reservoir with Cover
•
Safety Information document
•
RS-232 cable
•
Report of Test (store in a safe place)
•
Drain valve
•
Tipping Prevention Bracket (with included mounting hardware for wood or concrete floor)
•
2019-DCB Kit, Liquid-in-Glass (LIG) Adapter and Carousel (optional)
•
2069 Scope, Liquid-in-Glass (LIG) with mounts (optional)
If missing any item, contact Fluke Calibration. See
Uncrate and Move the Bath
When you uncrate the Bath, remove all of the accessories from the foam around the Bath and
remove the foam. Gently ease the Bath from the crate and use the casters to roll it. If you must lift
the Bath slightly to release it from the crate, have a second person help you. Carefully slide your
hands under the Bath and gently lift it only enough to clear the foam and roll the Bath from the
crate. The area that contains the compressor is heavier than the rest of the Bath. Do not attempt
to carry the Bath.
If you must move the Bath after installation, empty the bath fluid.
To prevent personal injury, do not move a bath filled with fluid. The Bath is tall and
heavy and personal injury or damage can occur. Unlock the casters to roll the
Bath.
4
Contact Fluke
:W
Warning
Calibration.
Advertisement
Table of Contents
