Table of Contents
Advertisement
INSTALLATION
30
6
Attach the neutral (white) wire to the center
screw of the terminal block.
7
Attach the power cord ground wire to the
green ground screw.
8
Tighten all screws securely.
9
Reinstall the terminal block access cover.
b
e
d
a
White Wire moved from Ground Screw
b
Hot Leads of Power Cord (Black and Red)
Neutral Wire (White)
c
Power Cord Ground Wire
d
e
Ground Screw
Four-Wire Direct Wire
• A UL-listed strain relief is
required.
• Use UL-listed 4-wire #10 AWG minimum
copper conductor cable. Allow at least 1.5 m
of wire to allow for removal and installation of
the appliance.
1
Remove 12.7 cm of the outer covering from the
wire and remove 12.7 cm of insulation from the
c
b
a
ground wire
. Cut off approximately 3.8 cm
a
from the other three wires and strip 2.5 cm
insulation from each wire. Bend the ends of the
three shorter wires into a hook shape.
Ground Wire
a
2
Remove the terminal block access cover on the
upper back of the appliance.
3
Install UL-listed strain relief into the power
cord through-hole.
4
Thread the 4-wire #10 AWG minimum copper
power cable prepared in step 1 through the
strain relief.
Terminal Block
a
UL-Listed Strain Relief
b
c
UL-Listed 4-Wire Power Cord
5
Transfer the appliance's ground wire from
behind the green ground screw to the center of
the terminal block.
WARNING
• This appliance is supplied with the neutral wire
grounded. This white ground wire MUST BE
127 mm
a
b
c
b
Advertisement
Table of Contents
