Kohler K-22106T-2 Installation Instructions Manual page 4

2. Install The Bowl
1) Put the bowl in position and mark a line along the back of
the bowl.
2) Place the template on the floor, align to the pencil line and
secure to the floor.
3) Drill the fixing holes with a 10 mm drill as indicated on the
template.
4) Fit the clamps to the floor with the floor plugs, washers
and nuts.
5) Position the bowl and install the soil pipe in accordance
with the manufacturer's instructions.
Note! An inlet isolating valve must be installed to the bowl.
6) Connect the inlet water supply to the bowl.
7) Secure the bowl in positon with the plastic sleeve and the
screw. Fit the plastic cover cap.
Back Edge of Pan
Wall
Installation Template
CONSUMER RESPONSIBILITIES
If you live in a hard water area, make certain that the holes in
the toilet rim are kept clean to ensure proper bowl flushing.
Toilet bowl cleaners should be used at least once a week.
Use a long-handled brush to clean the rim holes, and to clean
as far into the trap as possible to prevent mineral deposits
from forming.
Most toilet bowl cleaners are not harmful to the vitreous china
surface of the toilet bowl. Please follow the bowl cleaner
manufacturer's instructions carefully.
Do not use abrasive cleaners or solvents.
WARNING: Risk of property or product damage.
Do not use in-tank cleaners. Products containing
chlorine (calcium hypochlorite) can seriously damage
fittings in the tank. This damage can cause leakage
and property damage.
Kohler Company shall not be responsible or liable for any
damage to these tank fittings caused by the use of cleaners
containing chlorine (calcium hypochlorite).
WARNING: Risk of product damage.
Do not throw into the toilet what is easy to block it,
such as newspaper, paper pilch, sanitary towel.
Do not bump the vitreous china with great force to
prevent it from damaging and leaking.
Do not use the toilet in the water below 0 C.
CAUTION: Please do not use hard materials (like
scouring pad) to clean product surface, especially the
product logo.
1204812-T01-E
Back Edge of Pan
Fig.#3
3
o
2.
1)
2)
3) 10mm
4)
5)
6)
7)
Bolt
Washer
Clamp
Floor Plug
Fig.#4
4
o
0 C
-4-
Cover Cap
Screw
Plastic Sleeve
Fixing Hole
Fig.#5
5
( )