VTech SIP Contemporary Series User Manual page 10

Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown below.
• Plug the Cat-5 network cable into the RJ-
45 LAN port on the telephone base and
the network wall jack with Power over
Ethernet (PoE).
• NOTE: Power adapter is not required for
Power over Ethernet (PoE).
2
3
1 Network wall jack with Power over
Ethernet (PoE)
2 Cat-5 network cable
3 RJ-45 LAN port
2. Once installed, the telephone begins a four-
step initialization and system registration
process.
MUTE /
(1) The
on and then go off.
(2) The MUTE /
(3) The MUTE /
then the key flashes.
(4) The MESSAGE WAITING LED, LINE,
1
key and the key turn
key flashes.
key stops flashing and
MUTE /
500ms when initialization and system
registration are successful.
If the system registration fails, the
key blinks twice every second. To reset,
disconnect the Cat-5 network cable from the
network wall jack with Power over Ethernet
(PoE) and then reconnect.
CAUTIONS
Use only the supplied network cable.
The supplied network cable is not designed for
use in any other IT devices. Misusing it on your
other IT devices shall be prohibited.
To order a replacement,
call +44 (0)1706 694 070 or
email ukca@trustdistribution.com.
EN - 10
and illuminate for