Sip 1-line hidden base with cordless color handset and charger, sip 1-line hidden base, 1-line cordless color handset and charger, 1-line cordless color handset, charger
Analog 1-line hidden base with cordless colour handset and charger, virtual bundle 1-line cordless colour handset and charger, 1-line cordless colour handset, charger (41 pages)
Page 1
SIP Contemporary Series CTM-S2116 SIP 1-Line Hidden Base with Cordless Color Handset and Charger CTM-S2110 SIP 1-Line Hidden Base NGC-C3416HC Virtual bundle of NGC-C5106 and C5016 1-Line Cordless Color Handset and Charger NGC-C5106 1-Line Cordless Color Handset C5016 Charger User‘s Guide...
Important safety instructions The applied nameplate is located at the bottom or rear of the product. When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1.
Page 3
15. Avoid using a telephone (other than cordless) 22. Listed PoE (The product is considered not during an electrical storm. There is a remote likely to require connection to an Ethernet risk of electric shock from lightning. network with outside plant routing). 16.
Instructions de sécurité importantes La plaque signalétique appliquée est située au bas et à l'arrière de la base du produit. Lorsque vous utilisez votre équipement téléphonique, des précautions de base doivent toujours être prises pour réduire les risques d’incendie, d’électrocution et de blessure, notamment les suivantes :: 1.
Page 5
• Si le produit est tombé et que le socle 20. En position de montage mural, veillez à du téléphone et/ou le combiné ont été monter le socle du téléphone sur le mur en endommagés. alignant les oeillets avec les montants de fixation de la plaque murale.
| Network cable in the handset) S211X BASE Artwork RESET CTM-S2116 SIP 1-Line (virtual Hidden Base bundle of with Cordless CTM-S2110 + Color Handset NGC-C5106 + and Charger C5016) Rechargeable Li-ion Battery BT239865 Model No.:523450AR1000 3.7V 3.7Wh 1000mAh Caution: -Burn hazard, fire hazard, explosion hazard.
Page 8
Parts check list (continued) Parts included Cordless Model name Model number handset and Base station Handset Handset charger Base station wall mounting battery | Handset | Base Station Adapter plate (preinstalled charger adapter | Network cable in the handset) NGC-C3416HC 1-Line Cordless (virtual bundle Color Handset...
Screen icons Signal strength indicator at top left The signal strength is displayed The handset is out of range or the telephone base is turned off The handset is not registered to a no icon telephone base Battery strength indicator at top right Fully charged Normal Low battery...
SIP 1-Line Hidden Base with Cordless Color Handset and Charger - CTM-S2116 S211X BASE Artwork S211X BASE Artwork SIP 1-Line Hidden Base - CTM-S2110 Base Station Layout Base Station RESET FIND HANDSET button. • Short press to find the handset by making it ring.
VTech power adapter or using Power IMPORTANT INFORMATION over Ethernet (PoE Class 2) from your network. If 1. Use only a compatible VTech power adapter. you are not using PoE, install the base station To order a replacement power adapter, call near a power outlet not controlled by a wall 1 (888) 907-2007.
Page 13
To mount the base station on the wall 4. Check to make sure the plate is secure at top and bottom. It should be flush with the base 1. Install two mounting screws on the wall. station body. Choose screws with heads larger than 5.
SIP 1-Line Hidden Base with Cordless Installation Notes Color Handset and Charger - Avoid placing the base station, handset, or CTM-S2116 handset charger too close to: 1-Line Cordless Color Handset - • Communication devices such as television sets, players, other cordless NGC-C5106 telephones...
Handset Registration Handset Deregistration Follow the steps below to register your cordless 1. When a registered cordless handset is handset to the base station. idle, press the Lang soft key, and then 7 5 6 0 0 #. the key sequence: You can register additional cordless handsets to the base station.
3. Place the top of the battery in the handset Handset battery charging battery compartment so that the battery The battery must be fully charged before using connectors are aligned. the cordless handset for the first time. The battery 4. Push the bottom of the battery down into the charge light turns on when the cordless handset battery compartment.
Set up SIP 1-Line Hidden Base with Cordless Color Handset and Charger - CTM-S2116 Default settings are indicated by asterisks (*). Setting Options Adjustable by Listening volume- Handset 1, 2, 3, 4, 5, 6*, 7 User and administrator Ringer tone Tone 1* Administrator only All telephone settings are programmed through the administrative web portal.
Operation 3. To end the call, press End or place the handset in the charger. SIP 1-Line Hidden Base with Cordless Color Handset and Charger - Place a call during an active call CTM-S2116 1. During a call, press New on the cordless 1-Line Cordless Color Handset - handset.
Speakerphone Speed dial To dial a speed dial number: During a call, press on the cordless handset to switch between speakerphone 1. Press SpdDial. mode and handset earpiece mode. 2. Press to select a speed dial entry. • The icon appears in the middle of the screen when in speakerphone mode.
Appendix Troubleshooting If you have difficulty with the telephones, please try the suggestions below. For customer service, visit our website at www.vtechhotelphones.com or call 1-888-907-2007. For cordless telephone Question Suggestions • Make sure the Cat-5 network cable is NET port of the plugged into the base station and the network wall jack with Power over Ethernet (PoE).
Page 21
Question Suggestions • Try all the above suggestions. • A prefix may be required for dialing some internal or external calls. Refer to the SIP Phone Configuration Guide for details. 2. I cannot dial out. • Check your SIP server settings. If other SIP telephones in your hotel are having the same problem, the problem is in the wiring or network server.
Page 22
Question Suggestions • Make sure the cordless handset is placed in the handset charger correctly. The battery charging light should be on. • Remove the battery and then install it again. Charge it for up to 11 hours. • If the cordless handset is in the handset 6.
Page 23
Question Suggestions • Make sure the ringer volume is turned up on the cordless handset. • Make sure the Cat-5 network cable is NET port of the plugged into the base station and the network wall jack with Power over Ethernet (PoE). •...
Page 24
Question Suggestions • Make sure the Cat-5 network cable is plugged into the NET port of the base station and the network wall jack with Power over Ethernet (PoE). • Check your SIP server or telephone administrative settings. Refer to the SIP Phone Configuration Guide for details.
Page 25
Question Suggestions • Disconnect the base station from the network wall jack and connect a different working SIP telephone. Check your SIP 11. I hear other calls when using the telephone. server settings. If calls are still not clear, the problem is probably in the wiring or network server.
If VTech’s authorized service representative repairs the Product, new or refurbished replacement parts may be used. If the Product is replaced, it may be replaced with a new or refurbished Product of the same or similar design. Repair or replacement of Product, at VTech’s option, is the exclusive remedy.
Page 27
If the Product failure is not covered by this limited warranty, or proof of purchase does not meet the terms of this limited warranty, VTech will notify you and will request that you authorize the cost of repair and return shipping costs for the repair of Products that not covered by this limited warranty.
Appendix a telephone conversation, there may be interference. Precautions for users of implanted To improve reception, move closer to the base cardiac pacemakers station. Cardiac pacemakers (applies only to digital cordless telephones): About cordless telephones Wireless Technology Research, LLC (WTR), Privacy: The same features that make a cordless independent research...
Appendix FCC Part 68 and ACTA FCC, ACTA and IC regulations This equipment complies with Part 68 of the FCC rules and with technical requirements adopted FCC Part 15 by the Administrative Council for Terminal This equipment has been tested and found Attachments (ACTA).
VTech Hospitality limited warranty program in equipment and never directly to the network. the user’s manual. Industry Canada To ensure safety of users, the FCC has established This product meets the applicable Innovation, criteria for the amount of radio frequency energy Science and Economic Development Canada of the product.
Avertissement ISEDC Cet appareil est compatible avec la licence de l’Innovation, la Science et le développement économique du Canada à l’exemption des normes RSS. Le fonctionnement est sujet aux deux (2) conditions suivantes : (1) Cet appareil peut ne pas causer de l’interférence, et (2) Cet appareil doit accepter l’interférence, incluant de l’interférence qui peut causer un...
Avoid rough treatment by third parties that may arise through the use Place the handset down gently. Save the original of this product. VTech Communications, Inc. and packing materials to protect your telephone if its suppliers assume no responsibility for any you ever need to ship it.
Technical specifications SIP 1-Line Hidden Base with Cordless Color Handset and Charger - CTM-S2116 SIP 1-Line Hidden Base - CTM-S2110 1-Line Cordless Color Handset - NGC-C5106 Charger - C5016 Frequency control Crystal controlled PLL synthesizer Handset: 1921.536-1928.448 MHz Transmit frequency Base Station: 1921.536-1928.448 MHz...