Pilot Burner Adjustment; Fl Ame Characteristics - Napoleon Vector TLV50N Installation Manual

adjustments
EN

12.3 pilot burner adjustment

Adjust the pilot screw to provide properly sized fl ame. Turn in a clockwise direction to reduce the gas fl ow.
Check Pressure Readings:
Inlet pressure can be checked by turning screw (A) counter-
clockwise 2 or 3 turns and then placing pressure gauge tubing
over the test point. Gauge should read as described on the chart
below. Check pressure with main burner operating on "HI".
Outlet pressure can be checked the same as above using screw
(B). Gauge should read as described on the chart below. Check
pressure with main burner operating on "HI".
After taking pressure readings, be sure to turn screws
clockwise fi rmly to reseal. Do not overtorque.
Leak test with a soap and water solution.
Prior to pilot adjustment, ensure that the pilot assembly has not been painted. If overspray or painting of
the pilot assembly has occurred remove the paint from the pilot assembly, or replace. Fine emery cloth or a
synthetic scrub pad (such as Scotch-Brite™) can be used to remove the paint from the pilot hood, electrode
and fl ame sensor.
Min. Inlet Gas Supply Pressure
Max. Inlet Gas Supply Pressure
Manifold Pressure (Under Flow Conditions)
12.4 fl ame characteristics
It's important to periodically perform a visual check of
the pilot and burner flames. Compare them to the
illustration provided. If any flames appear abnormal,
call a service person.
If media trays are not required, remove and install glass media
for best fl ame and LED appearance.
56
W415-4121 / B / 04.20.23
Natural Gas
4.5" w.c. (11mb)
*7" w.c. (17mb)
3.5" w.c. (9mb)
Peak
Valley
B
A
INSERT PILOT ASSEMBLY
11" w.c. (27mb)
13" w.c. (32mb)
10" w.c. (25mb)
*Maximum inlet pressure not to exceed 13"
3/8" - 1/2"
(9.5mm - 12.7mm)
Flame must envelop
upper
3/8" to 1/2"
(12.7mm - 9.5mm) of
Flame sensor
TLV50 (NG) Illustrated
PILOT SCREW
Propane