Troubleshooting An Internal Sd Card; Troubleshooting Processors - Dell PowerEdge FC630 Owner's Manual
Hide thumbs
Also See for PowerEdge FC630:
- Getting started (2 pages) ,
- Owner's manual (143 pages) ,
- Getting started with your system (2 pages)
Table of Contents
Advertisement
Troubleshooting an internal SD card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Enter the System Setup and ensure that the Internal SD Card Port is enabled.
2.
Note the Internal SD Card Redundancy option is enabled in the Integrated Devices screen of the
System Setup (Mirror or Disabled).
3.
Turn off the sled using the operating system commands or the CMC.
4.
Remove the sled from the enclosure.
5.
If the Internal SD Card Redundancy option in the Integrated Devices screen of the System Setup is
set to Mirror mode and SD card 1 has failed:
a. Remove the SD card from SD card slot 1.
b. Remove the SD card present in SD card slot 2 and insert it into SD card slot 1.
c. Install a new SD card in slot 2.
6.
If the Internal SD Card Redundancy option in the Integrated Devices screen of the System Setup is
set to Mirror mode and SD card 2 has failed, insert the new SD card into SD card slot 2.
7.
If the Internal SD Card Redundancy option in Integrated Devices screen of the System Setup is set
to Disabled, replace the failed SD card with a new SD card.
8.
Install the sled in the enclosure.
9.
Turn on the sled.
10. Enter the System Setup and ensure that the Internal SD Card Port option is enabled and Internal SD
Card Redundancy option is set to Mirror mode.
11. Check if the SD card is functioning properly.
If the problem persists, see
Related Links
Removing the sled
Installing the sled
Removing a hard drive/SSD
Troubleshooting processors
1.
Turn off the sled using the operating system commands or the CMC.
2.
Remove the sled from the enclosure.
3.
Ensure that the processor(s) and heat sink(s) are properly installed.
4.
If your system only has one processor installed, ensure that it is installed in the primary processor
socket (CPU1).
5.
Install the sled in the enclosure.
6.
Turn on the sled.
7.
Run the appropriate diagnostic test. For more information, see Using System Diagnostics.
If the problem persists, see
Getting
Help.
Getting
Help.
Get other manuals https://www.bkmanuals.com
99
Advertisement
Table of Contents
Troubleshooting
