Table of Contents
Advertisement
Available languages
Available languages
2. To activate the filter, run tap water through the hole in the
centre of the filter until water comes out of the openings
at the side for more than a minute;
3. Extract the water tank and fill with water; insert the filter
in the water tank and immerse it completely for about ten
seconds, sloping it and pressing it lightly to enable the air
bubbles to escape;
4. Insert the filter in the filter housing and press as far as
it will go;
5. Close the tank with the lid, then put the tank back in the
machine;
6. Place an empty container with a minimum capacity of 0.5
litres under the steam/hot water spout.
7. See instructions in section "9. Settings menu" to install the
filter.
8. The appliance delivers hot water, then stops automatically;
9. The filter is now active and you can use the coffee
machine.
7.1 Replacing the filter
Replace the filter when the corresponding light
1. Extract the water tank and exhausted filter;
2. Follow the operations described in the previous section to
activate the filter;
3. See instructions in section "9. Settings menu" to set the
machine.
Please note:
After two months (see date indicator) or when the appliance
has not been used for 3 weeks, you should replace the filter
even if the message has not yet been displayed.
7.2 Removing the filter
If you want to use the appliance without the filter, you must
remove it and notify the appliance of its removal.
1. Extract the water tank and exhausted filter;
2. See instructions in section "9. Settings menu" to set the
machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if the
message has not yet been displayed.
8. TIPS FOR ENERGY SAVING
•
Set auto-off to 15 minutes (see "9. Settings menu");
•
Enable Energy Saving (see "9. Settings menu");
•
Always carry out the descaling cycle when prompted by
the machine.
comes on.
19
Advertisement
Chapters
Table of Contents
