Table of Contents
Advertisement
a.
Remove the display assembly panel from the base enclosure (see
45).
b.
Position the display assembly with the panel facing down and the bottom edge of the assembly
toward you.
c.
Attach two suction cups (1) to the display assembly. away from the camera module and bezel to
avoid damage (1), and then rotate the locking lever down to lock the cup (2).
d.
Use the suction cups and a case utility tool (3) to carefully separate the display panel assembly
from the display back cover (4). When releasing the display panel assembly, be sure not to attach
the suction cups to or insert the case utility tool into the area near the camera module in the center
of the display panel assembly.
e.
The display panel is secured to the display enclosure with tape that is installed under the left and
right sides of the panel. To remove the panel, use a utility tool to open the gap further (1). Use
tweezers to grasp the end of the tape (2). While turning the tweezers, wrap the tape around the
tweezers (3) as you continue to pull the tape out from behind the display panel (3). You must pull
the tape multiple times before it is completely removed.
f.
Rotate the display panel and place it next to the display enclosure and remove the panel (4). The
panel should be lifted about 15° from the bottom side.
Display panels are available as the following spare part numbers:
N13554-001: FHD, UWVA, antiglare, non touch screen, 300 nits
N13555-001: UHD, UWVA, antiglare, non touch screen, 400 nits
N13553-001: FHD, UVWA, antiglare, touch screen, 300 nits
54
Chapter 5 Removal and replacement procedures for authorized service provider parts
Display assembly panel on page
Advertisement
Table of Contents
