Drawing Hot Water; Drawing Steam And Milk Foam; Programming - Rotel U27.25 Instruction Manual

310324 rotel_U2725_U2730_inhalt_Rotel_Adagio277_Content

3.6 Drawing hot water

• Place your cup under the jet (8).
• Turn the steam/hot water dial (7) to the right.
• When your cup is filled with the desired amount of water turn the dial (7) back to 0.
☛
Caution: Very hot water and danger of burns! The water from the jet can
spray around, and the hot water jet (8) is very hot when in use. Allow the jet to
cool off for a few minutes before touching it.

3.7 Drawing steam and milk foam

• Press the steam/rinsing button (6). The button (6) begins to blink.
• As soon as the system is ready, the steam/rinsing button (6) will light up constantly
and the symbol
• Only for model U27.33: make sure that the «Cappuccinatore» control knob (12a) is
pointing to the neutral position (steam symbol).
• Insert the jet (8) into the cup with the liquid to be heated.
• Turn the steam/hot water dial (7) to the right. Please note: Water will first come out
and then steam.
• By turning back the dial (7) to 0, the process is stopped.
• Press the steam/rinsing button (6) and the coffee machine will be reset for normal
operation.
☛
You can make steam for up to two minutes. The machine will then turn off
automatically. By turning the knob (7) back and forth, you can continue the
process.
☛
Caution: Very hot steam and danger of burns! Only touch the jet on the black
plastic part!
☛
Dried residue on the jet after making milk foam is difficult to remove. You
should therefore clean it immediately after it has cooled off!

4. Programming

The following buttons are used for programming:
Coffee-strength button (3)
1-cup button (4)
2-cups button (5)
Steam/rinse button (6)
☛
You can reprogram the following settings:
Water hardness / Temperature / Standby time / ECO-Mode
☛
If the programming is interrupted for longer than 1
reverts automatically to the coffee ready mode.
blinks.
13.05.11 09:18 Seite 27
/ minutes, the machine
1
2
27