Introduction To The Control Panel; 1: Features - Honeywell NOTIFIER NFS2-3030 Programming Manual

Introduction to the Control Panel

DPI-232 Manual
TM-4 Installation Document (Reverse Polarity Transmitter)
UDACT Manual (Universal Digital Alarm Communicator/Transmitter)
ACT-1 Installation Document
ACT-2 Installation Document
VEC 25/50 Manual
RM-1 Series Remote Microphone Installation Document
RA400Z Remote LED Annunciator Document
RFX Wireless Interface Manual
UZC-256 Universal Zone Coder Manual
UZC-256 Programming Manual
XP Transponder Manual
XP10-M Ten Input Monitor Module Installation Document
XP5 Series Manual
XP6-C Supervised Control Module Installation Document
XP6-MA Six Zone Interface Module Installation Document
XP6-R Six Relay Control Module Installation Document
XPIQ Audio Transponder Manual
1.4 Introduction to the Control Panel
The NFS2-3030 is an intelligent Fire Alarm Control Panel (FACP) with features suitable for most
applications.
There are two basic configuration options for the NFS2-3030. It can be ordered with:
• a front display/keypad, which allows programming and viewing options at the panel, or
• no display/keypad.
This manual gives programming instructions using the front display/keypad.
Displayless Mode
When there is no keypad/display at the panel, it is controlled by remote annunciators. VeriFire™
Tools programming is required. The displayless panel has four buttons on its circuit board that are
service-level switches for local operation should it become necessary. They are the only buttons,
and are clearly marked with ACK for Acknowledge, SIGSIL for Signal Silence, SYSRST for
System Reset, and LAMP TEST. These buttons are mainly for installer use: the operator should
utilize a remote annunciator for these functions, if possible. The status indicator LEDs on the
circuit board are the same as on the display/keypad; refer to the NFS2-3030 Operating Manual for
LED descriptions.
Refer to VeriFire™ Tools for information on programming without an NFS2-3030 display/keypad.
A PC is required when using VeriFire™.
Canadian applications must conform to ULC requirements for displays and network control. Refer
to the Canadian Applications appendix in this panel's installation manual.
1.4.1 Features
Programming features include the following:
• Ease of use - Field program the control panel without special software skills.
NFS2-3030 Programming Manual — P/N 52545:A 11/29/2005
Table 1.1 Related Documents (2 of 2)
General Information
51499
51490
50050
52527
51118
50686
51138
I56-508
51012
15216
15976
15888
I56-1803
50786
I56-1805
I56-1806
I56-1804
51013
11