Troy-Bilt Storm 2420 Operator's Manual page 19

4. Apply a light coating of Bostik Regular Grade Never-Seez®
to the hex shaft. See Figure 6-3.
Figure 6-3
NOTE: When lubricating the hex shaft, be careful not to get
any oil on the aluminum drive plate or the rubber friction
wheel. Doing so will hinder the snow thrower's drive
system. Wipe off any excess or spilled oil.
Wheels
At least once a season, remove both wheels. Clean and coat the
axles with a multipurpose automotive grease before reinstalling
wheels.
Standard Chute Directional Control (Model 2410)
Once a season, lubricate the eye-bolt bushing and the spiral with
3-in-1 oil.
Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the flange bearings found at either end of the shaft. See Figure
6-4.
Figure 6-4
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved, adjust the shift cable as follows:
1. Place the shift lever in the fastest forward speed position.
2. Loosen the hex nut on the shift cable index bracket. See
Figure 6-5.
Figure 6-5
S 6 — M
ection
& a
aintenance djuStMentS
19