Troy-Bilt Storm 2420 Operator's Manual page 11

3. Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier.
See Figure 3-16.
Figure 3-16
4. Insert the chute directional control rod into the support
bracket on the rear of the dash panel. See Figure 3-17.
Figure 3-17
5. Remove the hairpin clip from the rear of the chute control
assembly. See Figure 3-18a.
6. Insert chute directional control rod into rear of the chute
control assembly. See Figure 3-18b. Secure the chute
directional control rod to the chute control assembly with
the hairpin clip removed earlier.
Figure 3-18
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. Store them in your snow
thrower's dash panel until needed. See Figure 3-19.
Figure 3-19
S
ection
a
b
3 — A & S -U
SSembly et p
11