Advertisement
®
MAGNUM PRO AL GUN LINER INSTALLATION GUIDE
LINER REMOVAL
This procedure will aid in the removal of the Magnum PRO AL
Gun liner. Carefully review all steps and corresponding
illustrations to ensure proper removal.This procedure should be
performed to its completion before installation of a new liner.
1. Lay the gun at, cut the zip tie at the front of the gun, and
undo cable cover.
2. Remove the nut on the back of the gun with a 5/16" wrench,
then loosen the bracket in the front of the gun with 3/32"
allen key.
3. Remove the four screws on the back of the gun with 5/64"
allen key to open rear casing.
4. Using a 3/32" allen key remove the setscrew holding the liner
5. Remove the six screws on the handle with 5/64" allen key to
6. Once the handle is removed, slide the molded strain relief
Loosen
7
conduit in place, and slide out through the cable strain relief.
open.
past the spiral strain relief and undo the spiral strain relief.
Remove the setscrew with a 3/32" allen key, pull the
liner out of the brass block and through the molded strain
relief.
REMOVAL
Advertisement
