Advertisement
Step Three
H
L.H. Bracket
P/N 3532
G
8/25/94
H
A
R.H. Bracket
P/N 3531
1/16I
G
Heat Sink
Plates
Ice Bank
Control relative
to agitator motor
angle.
3
S
Apply the Warning Decal (A) to the plate.
Place the plate in the unit with the decal on
the right hand side.
S
Tighten the plate to the basket with the hex
nuts. Apply the three screws to each side.
S
Remove the agitator fan blade.
S
Slide the rubber slinger off the shaft.
S
Remove the heat sink plates and remove
the cover.
S
Replace the slinger onto the motor shaft.
While the shaft is being pushed up into the
motor, adjust the slinger to 1/16I clearance
from the motor base.
S
Apply heat sink compound
(P/N 000113-734) between the brackets
(G), heat sink plates and the agitator motor
and assemble these parts as shown.
S
Place the agitator motor assembly into the
plate with the angle away from the ice bank
control bulb. Mark the mounting holes (H)
using the bracket as a template. Drill the
four holes with a #29 drill bit. Place heat
sink compound between the bracket and the
plate and screw in place.
S
Route the agitator motor electrical leads
through the left rear hole in the plate.
P/N 185211007
Advertisement
