Page 1
D. Disconnect the tubes to the valves. Raise the basket and remove the ice bank control holder by bending the top brackets. IMI CORNELIUS INC. One Cornelius Place Anoka MN 55303–6234 Telephone (800) 238–3600 Facsimile (612) 422–3246 KIT P/N 3626 P/N 185211007...
Page 2
Step Two P/N 3529 A. Snap the new ice bank control bulb holder (P/N 3529) onto the second and third coil from the top. B. Place the ice bank control bulb into the holder and secure it with two poly ties (P/N 040056-000).
Page 3
Step Three L.H. Bracket P/N 3532 Heat Sink Plates Ice Bank Control relative to agitator motor angle. 8/25/94 Apply the Warning Decal (A) to the plate. Place the plate in the unit with the decal on the right hand side. Tighten the plate to the basket with the hex nuts.
Page 4
Step Four Reconnect all product tubing. Be sure the tapered white nylon washers are in place. Route the tubing through the back hole of the panel and tie in place. Apply the DANGER decal to the top of the control box. Snap the grommet and the snap bushing into the holes of the control box as shown.