Cornelius Linus Series Manual

1. Introduction
Our foremost aim is to produce a quality product. If you should encounter any difficulty which these operating
instructions do not help you with, call or write us. We will be glad to be of assistance. If you write, please
include the model and serial number of the device.
Our address:
2. Safety Regulations
2.1 General Safety Regulations
This device is of leading-edge design and manufacture. If used and maintained in accordance with these
operating instructions, it will be safe to operate. Please comply with the following safety instructions to avoid
hazards and damage.
The device must be in satisfactory condition whenever operated. Any modifications which detrimentally affect
the safety of the device are therefore strictly prohibited. Please contact your service company if you wish to
obtain more information about safety.
No safety equipment (such as safety valves, overload protection devices, etc.) is to be removed, modified or
put out of commission (risk of injury or death!).
Take care that only authorized persons work on the device and that the operators are trained. Make certain that
no unauthorized persons change the settings on the device or tamper with it.
You are obligated to check the device on a daily basis for externally discernible damage and defects.
Immediately report modifications which affect safety and function to the service company nearest you.
Note that only original CORNELIUS replacement parts and accessories which have been checked and
approved are to be used. IMI Cornelius Deutschland GmbH assumes no liability whatsoever for damage
resulting from the use of non-original parts and accessories or from improper handling.
2.2 Safety Instructions Electricity
An electric shock may be fatal or result in serious injury. For this reason, any unauthorized tampering is strictly
prohibited.
Always pull out the mains plug before any cleaning work on or near the device. As delivered, it features a
moulded earthing-pin plug and it must be connected to a socket outlet with an earthing contact. This socket
outlet must be in reach ever! If no appropriate socket outlet with an earthing contact is available, the
connection must be made by authorized persons only, with the regulations applicable at the installation site
(EN standards in Europe, for example) being observed. The change of original spare parts must be
implemented by authorised Personal according to BGVA3 and VDE0701.
2.3 Safety Instructions CO
Place the carbon dioxide cylinder in an upright position next to the workstation and secure it against falling
over. Protect it against heat (e.g., against sunshine). Minimum distance from heater 0.5 m. Please only use food
approved carbon dioxide. Escaping carbon dioxide is heavier than air and may present danger of suffocation if
2
16
IMI Cornelius Deutschland GmbH
Carl-Leverkus-Strasse 15
D-40764 Langenfeld, Germany
Tel.: +49 (0) 2173 793-0
Fax: +49 (0) 2173 774 38
Internet: www.imi-cornelius.de
Linus