Table of Contents
Advertisement
INSTALLATION
A.
Remove Existing Toilet (If any)
Turn off the water supply. Flush the toilet， and use a sponge to remove the remaining water from the tank and
bowl. Disconnect water supply shut-off valve (if any)， and remove the residual tank and bowl.
Remove old gasket from the floor and toilet flange accessory bag with a putty knife. Dismantle residual T-bolts
and discard them.
NOTICE: if a new toilet is not installed immediately， temporarily stuff a rag in flange accessory bag.
B. Roughing-in
DANGER: Risk of electric shock. Disconnect power supply before servicing.
NOTE: This product is designed to work with wall mounted electrical and water supplies as shown in the mounting
dimensions.
WARNING: Risk of electric shock. Connect only to circuits protected by Ground-Fault Circuit-Interrupters (GFCI's)
or Earth-Leakage Circuit-Breakers (ELCB's).
Keep bath and shower head away from electrical parts (such as remote controller， receptacle etc). When the
electrical supply is mounted on the wall， an anti-splash and waterproof receptacle is required.
1383620-KR01-A
Flange accessory package
Water inlet (G1/2 ID)
Fig 4
Mounting holes (total 5)
Fig 5
6
Unit: mm
Kohler Co.
Advertisement
Table of Contents
