GENERAL SAFETY INFORMATION RECEIVING, MOVING, AND UNPACKING PRESSURIZED DEVICES: A. RECEIVING This equipment is a pressure This shipment has been thoroughly checked, packed containing device. and inspected before leaving our plant. It was received in good condition by the carrier and was so •...
INSTALLATION System Arrangement Liquid water in the inlet air will adversely affect the performance of the dryer. Install the dryer downstream of Ambient Air Temperature Locate the dryer indoors where the ambient air temperature an aftercooler or separator so that the temperature of the will be between 40°F and 100°F.
INSTRUMENTATION START-UP/OPERATION ON/OFF Switch Follow the procedure below to start your dryer. Failure to The dryer is equipped with an ON/OFF switch on the front follow the prescribed start-up procedure will invalidate the panel. A light signals when the dryer is on. warranty.
MAINTENANCE Remove screw and washer from front of the drain valve. Remove the power supply connector and gasket (with the timer assembly if attached) from the solenoid coil The dryers require little maintenance for satisfactory housing. Do not damage or lose the gasket. operation.
FIELD SERVICE GUIDE refrigerants to the atmosphere. All refrigerants must be Problems most frequently encountered with refrigerated recovered per EPA requirements. Do not smoke when a dryers are water downstream of the dryer and excessive refrigeration leak is suspected. Burning materials may pressure drop.
The manufacturer does not warrant any product, part, material, component, or accessory manufactured by others and sold or supplied in connection with the sale of manufacturer's products. 2/96 AUTHORIZATION FROM THE SERVICE DEPARTMENT IS NECESSARY BEFORE MATERIAL IS RETURNED TO THE FACTORY OR IN-WARRANTY REPAIRS ARE MADE. SERVICE DEPARTMENT: (724) 746-1100 Canonsburg, PA 15317-1700 U.S.A. Tel 724-745-1555 Fax 724-745-6040 hankison.service@airtreatment.spx.com...