Table of Contents
Advertisement
<< PARAMETER SETTINGS >>
Item
Description
Value to be printed
MEDIA LOAD [ ]
[Description] Media feed to the print start position
[Values to be printed]
OFF:
Disabled.
STD:
Feeds the detected gap/mark to the print start position.
ECO: Feeds a gap/mark positioned between the print head and the media sensor, if any, to the print
start position.
ECO+Bfeed: Back feed follows the above ECO printer behavior.
MOVE TO TEAROFF [1] [2] [3]
[Description 1] Auto feed to the cut/strip position after printing
[Value to be printed 1]
OFF: Disabled.
ON:
Enabled. The following media stop position fine adjustment value is also printed.
[Description 2] Media stop position fine adjustment value
Note: Printed only when the "Auto feed to the cut/strip position after printing" is set to ON.
[Value to be printed 2]
-5.0mm to+5.0mm
[Description 3] Feed mode
[Value to be printed 3]
MODE1: Feeds the media for 13.7 mm.
MODE2: Reserve.
PRE PEEL OFF [ ]
[Description] Whether to enable the pre-peel-off function
[Values to be printed]
OFF:
Enabled.
ON:
Disabled.
BACK FEED SPEED [ ]
[Description] Reverse feed speed
[Values to be printed]
STD:
3 ips
LOW: 2 ips
CALIBRATION [ ]
[Description] Automatic calibration
[Values to be printed]
OFF:
ON TRANS.: Auto calibration is performed with transmissive sensor.
ON REFL.:
ON ALL:
ON TRAS+BF: Auto calibration is performed with transmissive sensor, then the media is reversely fed.
ON REFL+BF: Auto calibration is performed with reflective sensor, then the media is reversely fed.
ON ALL+BF: Auto calibration is performed with both sensors, then the media is reversely fed.
CODE PAGE [1] [2]
[Description 1] Character code selection
[Value to be printed 1]
PC-850
Disabled.
Auto calibration is performed with reflective sensor.
Auto calibration is performed with both sensors.
57
Advertisement
Table of Contents
