Table of Contents
Advertisement
Auto configuration mode
Notes:
1. To enter the download mode, system mode or auto configuration mode, keep holding down the specified key
until each menu is shown.
2. Power off
When the power of the printer is turned off(Enter Power SW key), the ONLINE and ERROR LEDs
synchronously flashes (ON: 250ms, OFF: 250ms). When the LEDs are unlit, the printer power turns off.
The printer power shall not be turned on again while these LEDs are flashing. Otherwise, "SYSTEM ERROR
02 POWER FAILURE" message will be displayed, and the LCD message may corrupt before the error
message is displayed.
3. For the conditions to enter the Auto Configuration Mode, refer to Section11.2 Preparation for USB Memory.
USB TO PRINTER
Config file test
TOSHIBA tec
10
Advertisement
Table of Contents
