Table of Contents
Advertisement
the wave director.
・ FRONT
・ CENTER
・ REAR
<Combination of the RF antenna and the wave director>
Antenna position
FRONT
CENTER
REAR
Notes:
1. A "usable" antenna position must be selected for this parameter.
2. If an RFID calibration is performed with "Unusable" antenna position selected, the printer operation is
not guaranteed. (Refer to Section 6.7.1 Outline of the RFID Calibration.)
3. For details of the RFID calibration, refer to Section 6.7 RFID.
8.10.5 OTHER
The menu structure of OTHER
Menu item
<7>RFID
OTHER
TAG CHECK
MULTI WORD WRITE
8.10.5.1 TAG CHECK
・ OFF:
Error tag detection is not performed.
・ ON (ID):
Error tag detection is performed.
・ ON (ACCESS PASSWORD):
Notes:
1. Description of the options
・ OFF:
Error tag detection is disable.
Though a tag is read before writing data on it, data is always written on the tag whatever data is
set as the header data.
・ ON (ID):
Error tag detection is enable.
A tag (EPC area for GEN2 tags) is read before writing data on it, and data is written on the tag
only when the header data is "A5A5".
・ ON (ACCESS PASSWORD):
2. To prevent unauthorized changes of the setting, a password can be set to protect the error tag detection
setting. (For the password setting procedure, see below.)
Antenna rotation
Wave director position
0°
Error tag detection is performed.
Error tag detection is enable.
Error tag detection is enable only for GEN2 tags. The access password
area of a tag is read before writing data on it. Only when the data read
matches the access password setting data, the data is written on the tag.
124
Application
0 mm
Usable
Unusable
Unusable
Advertisement
Table of Contents
