Table of Contents
Advertisement
SYSTEM ASSEMBLY
Coupling Cold And Hot Pipes To Collector – Screwed Fittings
Refer to the
exploded view diagrams
on page 46.
Seat an O'ring (11) into the collector connection.
1.
2.
Place the end of the solar hot pipe into the collector connection and screw in the union until it seats firmly
against the O'ring (11), applying medium pressure with a spanner to tighten.
Repeat this procedure to couple the solar cold pipe to the solar collector.
3.
on pages 35
and
36 for position and
DETAIL F
Hot Pipe to Collector Assembly
DETAIL G
Cold Pipe to Collector Assembly
46
Detail F
on page 46 and
Detail G
Advertisement
Table of Contents
