Rheem Solar Hiline 52D Series Owner's Manual And Installation Instructions page 44

SYSTEM ASSEMBLY
Clamping Collector To Collector Rail
Refer to exploded view diagrams
position and to Detail B.
Position the collector clamp (16) over the hole in the
1.
collector rail (6) with the top lip of the clamp (16) over
the collector trim.
2. Insert the hex screw (14) through the hole in the
collector clamp (16) and collector rail (6), place the
washer (36) and nut (15) on the hex screw (14) and
screw the nut (15) until it seats firmly against the lip of
the collector rail (6), applying medium pressure with a
spanner to tighten.
Hooking Roof Strap to Tank Clamp
The tank clamp (5) is supplied as a single
1.
extruded part and must be snapped into two.
Snap by bending the clamp on the groove
location.
Noting the orientation of the roof strap's folded
2.
end, slide the short end of the roof strap (4)
through the slot from the underside of the tank
clamp (5).
Push the roof strap (4) end through the tank
3.
clamp (5) and make sure it is correctly orientated
as illustrated.
on pages 35 and 36 for
4.
44
209130
331842
209124
209118
204600
DETAIL B
Collector Rail Collector Clamp Installation
Loosely pre-assemble the hex screw (14),
washer (36) and nut (15) as shown. Ensure the
hex screw head fits into the valley of the tile or
roof sheet profile.
nut (15)
washer (36)
tank clamp (5)
roof strap (4)
washer (36)
hex screw (14)
Tank Rail Fixing
nut (5)
washer (36)
clamp (5)
strap (4)
washer (36)
hex screw
(14)
Tank Clamp Assembly
DETAIL C
collector rail