Table of Contents
Advertisement
Coupling Collector To Collector – Screwed Fittings
Refer to the
exploded view diagram
Seat an O'ring (11) into each of the collector connections to be joined.
1.
2.
Fit a collector union (12) to each collector connection of the first solar collector to receive the second solar
collector and screw in the unions until they seat firmly against their O'ring (11) in the collector connection.
Hand tighten only so the solar collectors can be shifted and centred.
3.
Place the collector unions (12) into the collector connections on the second solar collector and screw in
the unions until they seat firmly against their O'ring (11) the collector connection. Hand tighten only so the
solar collectors can be shifted and centred.
After the solar collectors are centred on the collector angle, tighten each collector union (12) with a
4.
spanner applying medium pressure.
End Plug Assembly – Screwed Fittings
Refer to the
exploded view diagrams
Seat an O'ring (11) into the collector connection.
1.
Place a blanking disc (22B) over the seated O'ring (11). The blanking disc (22B) should be installed with
2.
the smooth edge facing into the collector.
3.
Place the end plug into the collector connection and screw in until it seats firmly against the blanking
disc (22B), applying medium pressure with a spanner to tighten.
on page 36 for position and
DETAIL D
Collector Union Assembly
on pages 35
and
36 for position and
Gland Nut M33 End Plug
DETAIL E
End Plug Assembly
45
Detail D
on page 45.
Detail E
on page 45.
P/No: 063600
SYSTEM ASSEMBLY
Advertisement
Table of Contents
