Makita DBO180 Instruction Manual page 7

Emptying dust bag
1
► 1 . Dust nozzle
When the dust bag is about half full, switch off the tool, and
remove the dust bag from the tool. Then remove the dust nozzle
from the dust bag after unlocking the dust nozzle by turning it
slightly counterclockwise. Empty the dust bag by tapping it lightly.
1
► 1 . Dust nozzle
After emptying the dust bag, install the dust nozzle on the dust
bag. Turn the dust nozzle slightly clockwise to lock it in place. Then
install the dust bag on the tool as described in "Installing dust bag".
Installing paper filter bag (Optional
accessory)
► 1 . Holding tab
Make sure that the logo on the cardboard lip and the
logo on the dust box are on the same side, then install
the paper filter bag by fitting the cardboard lip in the
groove of each holding tab.
► 1 . Dust box 2. Dust nozzle
Make sure that the logo on the cardboard lip and the
logo on the dust nozzle are on the same side, then
install the dust nozzle on the dust box.
Removing dust box and paper
filter bag
1
► 1 . Latch 2. Dust nozzle
Remove the dust nozzle by pushing the two latches.
1
Remove the paper filter bag first by pinching the logo
side of its cardboard lip, then by pulling the cardboard
lip downwards to move it out of the holding tab of the
dust box.
7 ENGLISH
1
2
2