Installation; Installation Requirements; Requirements Summary; Electrical Requirements - Cornelius Impulse Non-Carbonated Post-Mix Beverage Dispenser Installation And Operation Manual

Non-Carbonated Impulse Installation & Operations Manual
CAUTION
cians should service this unit. ALL WIRING AND PLUMBING MUST CONFORM TO
NATIONAL AND LOCAL CODES.
NOTE: Water pipe connections and fixtures directly connected to the potable water supply must
be sized, installed, and maintained in accordance with NSF Standard 18, as well as Federal, State,
and Local codes.
NOTE: It is the installer's responsibility to ensure that the water supply is equipped with protec-
tion against backflow. This protection can be an air gap as defined by ANSI/ASME A112.1.2-1979,
or by an approved vacuum breaker or other approved method.
I R
NSTALLATION EQUIREMENTS

Requirements Summary

Weight: .................front or rear counter must be level and able to support 400 lbs.
Environment:........indoor installation only
Temperature:........40 to 110° F ambient temperature
Clearance:............18-inches above
6-inches on sides and rear
CO : .....................75 psi (5.25 bar) at unit with internal carbonator
2
Concentrate: ........60 psi
Water:...................50 psi maximum
Electrical: .............see nameplate on unit for electrical requirements

Electrical Requirements

Before connecting electrical power to the unit refer to nameplate to verify power requirements.
DANGER
breaker) must be installed in electrical circuit of all 50 Hz units.
WARNING
using the green grounding screw provided inside the electrical contractor box.
CAUTION
disconnect switch (slow–blow fuse or equivalent HVAC/R circuit breaker). ALL WIRING
MUST CONFORM TO NATIONAL AND LOCAL CODES. MAKE SURE UNIT IS PROP-
ERLY GROUNDED.
Publication Number: 859000159INS

INSTALLATION

— Only trained and certified electrical, plumbing and refrigeration techni-
— To avoid possible serious injury or death the ELCB (earth leakage circuit
— To avoid possible electrical shock the unit must be electrically grounded
— The wiring must be properly grounded and connected through a 10-amp
- 2 - © 2003, IMI Cornelius Inc.