Table of Contents
Advertisement
Chapter 3. Installing Camera & Network Setup
On-wall Mount Type Installation Example
How to Set Up Install Base
•
1. Open Hinged Door
As shown in the picture below,
gently press and lift up the handle
of the hinged door on the bottom of
the install base.
2. Connect Terminal Wires
Connect each wire to the pertinent
terminal block.
For more detailed instructions,
please refer to the "Camera Wiring
Interface Board" on Page 16.
Once all the wires are connected,
close the hinged door.
Caution
• M ake sure to first hook the camera's safety cable to the mount before proceeding. Otherwise you may
be exposed to serious injury caused by a fallen camera.
NETWORK PTZ CAMERA
Audio IN/OUT
User Manual
34
Knob
Lan
Video Output
Advertisement
Table of Contents
