Scanning Statement Values - Viessmann VITOSOLIC 200 Operating Instructions Manual

Scanning options
Calling up messages
Press the following keys:
1. for the "Main menu".
2. for "Messages".
"Messages:"
No fault
"Loading cyl"
(only with several consumers)
"Pause cyl"
(only with several consumers)
"Cyl. set"
"Fault"
"SW version"
"HW version"

Scanning statement values

Press the following keys:
1. for the "Main menu".
2. for "Solar".
3. OK to confirm.
"Statement"
"Colmax"
"Col2max"
"Cylmax"
"Cyl2max" to "Cyl4max"
"Relay 1" to "Relay 7"
"Days"
To reset the values, except value for days in opera-
tion:
Whilst the value is displayed, press the following keys:
1. OK "Delete?""Yes" is displayed.
6
Explanation
There is no fault at the solar control unit.
The display shows which consumer is being heated.
Only if the "Cyclical heating" function has been enabled by your heating
contractor:
Pause in the heating of the displayed consumer.
The consumer displayed has reached its set value.
A fault has occurred at the solar control unit (to check the cause, see
page 9).
Software version (only for service engineers)
Hardware version (only for service engineers)
Explanation
Maximum collector temperature in °C
Maximum collector temperature in an additional collector array in °C
Maximum cylinder temperature in °C
Maximum cylinder temperature for additional consumers (e.g. 2nd DHW cylinder)
in °C
Hours run of the actuators connected at the relay (e.g. solar circuit pump at R1)
Days in operation, solar control unit
3. OK to confirm.
4. to display further messages (see table below).
4. for "Statement".
5. OK to confirm.
6. / for the following statement values, subject to
system equipment level.
7. until the "Main menu" appears.
2. OK to confirm