Samsung WD10K6 Series User Manual page 58

Hide thumbs Also See for WD10K6 Series:
Table of Contents

Advertisement

Troubleshooting
Problem
HC
1C
8C
AC
AC6
DDC
If any information code keeps appearing on the screen, contact a local Samsung service
centre.
58 English
WD90K6410OX_03745E-02_EN.indd 58
High temperature heating check
• If the information code remains, contact a customer service
centre.
The WaterLevel sensor is not working properly.
• Try power off and restarting the cycle.
• Check WaterLevel Sensor wire harness.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the "1C" code, the washer do
draining for 3 minutes. During this time, the Power button is
inoperative.
The MEMS sensor is not working properly.
Turn the machine off, and restart the cycle.
If the information code remains, contact a customer service
centre.
Check communications between main and sub PBAs.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service
centre.
Check communications between main and inverter PBAs.
Depending on the state, the machine may automatically returns
to normal operation.
Turn the machine off, and restart the cycle.
If the information code remains, contact a customer service
centre.
This message appears when you open the Add Door without
pressing Pause. If this happens, do one of the following:
To add laundry, press the Add Door to close it properly. Then,
press Start/Pause and try again.
If you press the Add Door by mistake, press the Add Door
again to close it properly. Then, press Start/Pause to resume
operation.
Action
2016/11/10 17:01:29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd90k6 seriesWd80k6 seriesWd80k6410owWd10k64 series

Table of Contents